STEP 7-Micro/WIN V4.0 Instrukční strom ‘Stránkování‘ datového bloku Vylepšené funkce PID Auto-Tune Stromy výběrů Vylepšené diagnostické funkce Grafy trendů Průvodce pro PTO Průvodce recepturami Průvodce záznamem dat Podpora paměťových modulů Nový datový typ: řetězec Ochrana projektu Nové instrukce PLC Podpora TD 200 Přehled Vyžaduje: Windows XP nebo Windows 2000ģ Instrukční strom Co je nového Stránky datového bloku Křížové odkazy Customers with earlier OS’s (Win95,Win98,WinNT) must use Micro/WIN V3.2 or earlier.Ģ S7-200 Software: vylepšení ve verzi 4.0
Only Windows 2000 & Windows XP operating systems are supported. Micro/WIN V3.X (or greater) can be upgraded to the NEW Version 4.0 You can open or upload all old projects (created with any Micro/WIN version it will not open Micro/DOS projects). Save, Download and Close Hardware Configuration.1 STEP 7-Micro/WIN V4.0 Siemens Micro Automation Software Set Pg/Pc interface on TCP/IP and check that plcSim is using TCP/IP too: In my project this is the configuration of ethernet card: Now the PC that is running Step 7 and PLCSim is the PLC, this means that PC and ethernet card must have the same IP Address and if you are communicating with another PC you have to set also the router address. Let’s create a new project, add a s7 300-2DP (standard configuration) and an ethernet card CP-343-1.
With NetToPLCSim you are able to connect your SCADA/HMI-systems via S7-communication to PLCSim over TCP/IP, and read/write data areas from your simulated PLC.Ģ- Ethernet cable plugged in (some peoples says this is needed)ģ- Port 102 Opened (so exception in your firewall and shutdown s7oiehsx service (command line from start -> run : net stop s7oiehsx) This is a tutorial on how to connecto to NetToPlcSim. The official site to download the program is here:
0 kommentar(er)
